20 inch horton bolts..

dodgetech · Post by **dodgetech** » Mon Aug 21, 2006 5:55 pm

these bolts are 20 inch nocks cut not flat can i use these accurately in my exocet??the are horton bolts??

Rich · Post by **Rich** » Mon Aug 21, 2006 7:27 pm

I just sanded the halfmoons flat with my dremel tool and it worked fine. They fly consistent but about 6-8 inches different than my GT II's though.

dodgetech · Post by **dodgetech** » Mon Aug 21, 2006 7:39 pm

well i was told by my pro shop thats a excal dealer theyd be fine and yes they were indeed no problems at all very accurate,,these are factory horton bolts,,just shot my exocet and was very pleased even with the peep site,,

BigBear · Post by **BigBear** » Tue Aug 22, 2006 4:29 pm

dodgetech wrote:well i was told by my pro shop thats a excal dealer theyd be fine and yes they were indeed no problems at all very accurate,,these are factory horton bolts,,just shot my exocet and was very pleased even with the peep site,,

I've been to some shoots, and have seen some guys shooting excal's with the moon nocks....they told me that they shoot just fine...also helps out with the center serving as well...just make sure the spam vane is down..

Hope this helps..BB

Excalibur Crossbow Forum

20 inch horton bolts..

20 inch horton bolts..

bolts

Re: bolts