Has anyone tried these??

yakman$ · Post by **yakman$** » Fri Apr 03, 2009 8:11 am

I need to get a new set of BH and bolts before the season starts. WOO HOO

Has any one tried these new bolt cutters and fire bolts from EXCALIBUR

Not sure if this matters but i am shooting a Exomax...

Yakman$

Kelley · Post by **Kelley** » Fri Apr 03, 2009 9:00 am

They fly well. I harvested a doe with a Boltcutter last Fall.
Kelley

cdup · Post by **cdup** » Fri Apr 03, 2009 8:50 pm

A friend of mine took a doe at 20yds with that same set up and she only went 40yds. I also hunt with the boltcutters, just haven't had the chance to use them!

vixenmaster · Post by **vixenmaster** » Sat Apr 04, 2009 6:50 am

i used a Boltcutter to harvest a 6 pt. did the job, was accurate.

yakman$ · Post by **yakman$** » Sat Apr 04, 2009 10:32 am

I think i am going to get a set i need new ones......

one shot scott · Post by **one shot scott** » Sat Apr 04, 2009 10:35 am

I switched to boltcutters after slick tricks. I found them more accurate
Make sure those inserts on the firebolts are glued in good!

yakman$ · Post by **yakman$** » Sat Apr 04, 2009 10:39 am

one shot scott wrote:I switched to boltcutters after slick tricks. I found them more accurate
Make sure those inserts on the firebolts are glued in good!

I am thinking of getting a set of Lumenok's...

What do you think???

one shot scott · Post by **one shot scott** » Sat Apr 04, 2009 10:46 am

Ive used the luminoks too. I find them vey helpful in knowing where your shot placement on an animal is. I adjust my recovery time according to that info. Luminoks add weight to the back of the bolt though. with the firebolts they should work well, they dont work with the gtII bolts that excalibur had in their old kits. But perhaps that was because i was using the wrong luminoks?