Cleaning a Excal trigger assembly???
Moderator: Excalibur Marketing Dude
I've used WD-40 & compressed air to clean mine, but you have to be very careful with WD-40 it is not really synthetic friendly. I do not like to use much lube in the trigger, because it collects dust & dirt and results in that gritty pull. I usually spray some RemOil on it, then use compressed air to remove the excess.
wabi
-
- Posts: 38
- Joined: Sun Nov 23, 2008 6:55 am
- Location: Pickering, Ontario
Use Eezox!
http://www.eezox.com/index.html
It goes on wet and dries making the steel highly rust resistant and lubricated.
I does smells a bit untill it dries (a few days) so don't put it on and go deer hunting if you worry about sent.
http://www.eezox.com/index.html
It goes on wet and dries making the steel highly rust resistant and lubricated.
I does smells a bit untill it dries (a few days) so don't put it on and go deer hunting if you worry about sent.
08 Equinox, #1989 string, FireBolts with NAP QuikSpin ST Speed hunter vanes, 150gr. Boltcutter BH's, Lumi-Zone scope.