STS Rod

Snuffy · Post by **Snuffy** » Thu Sep 17, 2009 4:29 pm

My STS rod needs to be trimed the STS sets to deep into the string. How much should I trim the STS rod???

Mike LaFleur · Post by **Mike LaFleur** » Thu Sep 17, 2009 5:26 pm

I had the same problem and trimmed mine till the back of the rubber touches the block,I measured from rubber to block and it came to approx,1/4" you have a little to play with with lock screw,,,hope this helps!!

xbow_cas · Post by **xbow_cas** » Thu Sep 17, 2009 8:20 pm

Rather than cutting my post I picked up a 3/8" diam. Aluminum rod from Lowes and cut myself new posts. No worries about cutting to short and much easier than trying to trim off a small amount from the original posts.

michiganman · Post by **michiganman** » Thu Sep 17, 2009 9:05 pm

like above i cut mine down so the stoper is against the block,and thats about were i want my brace heigth.you want rod in block all the way,and also in the stopper all the way,or you will split it.mine was about a 1/4" off,JIM