cheap cross bow stand

[steve ypsi mi]

The one made by excalibur is really nice and cheap but I haven't gotten around buying one for my new Phoenix yet so I took a piece of 3/4 scrap plywood 9 1/2 wide and 28 tall and made one using 1 inch dowel drilled holes tight to fit and drove them in no glue (1 inch dowel is what I had on hand) 1/2 inch dowel would probably work fine
Got tired of proping it up on a chair, the suport legs just used 1/8 rope to act as hinges 1/8 inch rope 12 inchs worked out
Not pretty but does the job

[Island Hunter]

This one cost about 10 or 15 dollars.

[steve ypsi mi]

This one cost about 10 or 15 dollars.
saw yours but didn't want to go buy all the fittings and pipe and cut a lot of parts. just wanted a temporary stand

[Island Hunter]

OK I didn't know if you had seen it. It really isn't that hard to make, took me less than an hour, and that was figuring it out too.

[steve ypsi mi]

It really isn't that hard to make, took me less than an hour, and that was figuring it out too.

but you forget, I am old and senile, every thing is hard for me

[awshucks]

but you forget, I am old and senile, every thing is hard for me

You guys will fit right in here, lol. We got beau coup tweakers.

Steve, to make a partial quote on a post, high light it [left click, drag] and then rt click for 'copy', then in your post type
Bracket[next to 'P' , the word quote, then bracket, space, then bracket slash [under ? mark] quote bracket. Here's an example not using the word quote.
[xxxxx] [/xxxxx]

paste what you copied in the space between the 2. Only took me about 1.5 yrs to find this, lol.

[steve ypsi mi]

( paste what you copied in the space between the 2. Only took me about 1.5 yrs to find this, lol)

man that took 4 hours to figure out now I have to take a nap like old men do