Cheekpiece for Axiom

[allanshumiao]

How does the cheekpiece attach to the stock? Do you drill a hole for the machine screw? I can't see the attachment from any sales site and only description is that the piece snaps on and is attached with a machine screw. Can you enlighten me on how it attaches? Thanks, allanshumiao

[shooter00]

There's a predrilled hole in the top of the cheek piece and the top of the buttstock.
Once you snap it on you nudge the cheek piece to align the holes and put the screw in.
Getting the cheek piece aligned to push/snap into place takes a little trial and error but simple after you do it the first time....

[allanshumiao]

Thanks, I'll take a closer look at the stock.. Thanks again. allanshumiao

[maine hunter]

here's alittle tip for you. take the cheek rest and use a hairdryer and heat it up. don't over heat.just enough for the cheek plate to snap into place. it helps alot!!! good luck.

[buckknife]

If you go to where it says support and click on the instructional videos it has a video on had to mount the cheek piece.

[robertyb]

X-2 on using a hair dryer. Makes a hard job easy.