BCY Angel Majesty Serving

[Champboy]

Does anyone know where I can but Angel Majesty .036 serving thread. I can find .026 but I can't find .036 anywhere.

[GrassyKnoll]

Danny Miller sells it..

(740) 483-2312

[Champboy]

Thanks for the info. I've searched the internet everywhere and couldn't find any.

[GGC]

Just remember BCY located in Ct. makes majesty.
The Angel Co. makes angel majesty, they are in Japan.
You want angel majesty from D Miller.
Totally different servings.

[Champboy]

Thanks Again, I hear it is really good center serving. I'm using halo now but would like to try Angel Majesty.

Thanks

[strum]

Thanks Again, I hear it is really good center serving. I'm using halo now but would like to try Angel Majesty.

Thanks

the best serving by far. The hardest part is the back serve..its so abrasive youll want to put plenty of wax and pull sloooowly..

[8ptbuk]

Thanks Again, I hear it is really good center serving. I'm using halo now but would like to try Angel Majesty.

Thanks

the best serving by far. The hardest part is the back serve..its so abrasive youll want to put plenty of wax and pull sloooowly..

X2 ! What strum said !

[Boo]

BCY imports and sells Angel Majesty.
Here's some interesting info. Our resident hero got 750 shots out of his Vortex. Back then, it wasn't unusual to see a serving bite the dust after 100 to 200 shots on the big boys.
http://www.excaliburcrossbow.com/phpBB2 ... el+Majesty
Angel Majesty serving is the best so far. I recently did a test on the forum with BCY's Powergrip and it was a failure.

[snuffbox]

I can only find .021 here in UK.
I assume that's too thin.

[Boo]

I can only find .021 here in UK.
I assume that's too thin.

The smallest diameter you should use is 0.026".
You can order 0.035" direct. If you order a jig spool you'll find that it does not fit most tools. Best to buy the large bulk spools.

[Champboy]

Thanks Boo, I ordered some from Dan Miller Today.

[snuffbox]

I can only find .021 here in UK.
I assume that's too thin.

The smallest diameter you should use is 0.026".
You can order 0.035" direct. If you order a jig spool you'll find that it does not fit most tools. Best to buy the large bulk spools.

Thanks for that Boo.

[awshucks]

Danny Miller told me that it costs him $1 per serving to use AM..............