Ramcat 125???
Moderator: Excalibur Marketing Dude
Ramcat 125???
I read the other post but couldnt get a clear answer. I see the ramcat 125 is 1 1/2 inch cut, can anyone verify that it will clear the factory stirrup on a bulldog 400 with factory 18" diablos? Thanks!!!
BullDog 400
Hawke XB30 Pro SR
18" Diablo
125gr NAP KIllzone
125gr Grim Reaper Fatal Steel
Hawke XB30 Pro SR
18" Diablo
125gr NAP KIllzone
125gr Grim Reaper Fatal Steel
Re: Ramcat 125???
Stick your arrow in backwards and measure from bottom of the arrow to the stirrup. You should be fine. Arrow OD is .343" so subtract .172" from .750" and you'll know. Also, you can insert the arrows when shooting with one blade pointing up to increase the clearance.
It’s not the way you rock, it’s the way that you roll!
-
nchunterkw
- Posts: 2906
- Joined: Sat Dec 24, 2011 11:21 am
- Location: Wake Forest, NC
- Contact:
Re: Ramcat 125???
They clear my Micro....so I would assume the BD400 too. But double check as Xcalibur said above
Keith
Stand by the roads and look, and ask for the ancient paths; where the good way is,
and walk in it and find rest for your souls. - Jer 6:16
Micro 335 & 355
deerboyarchery.wixsite.com/trinitystrings
[email protected]
<{{{><
Stand by the roads and look, and ask for the ancient paths; where the good way is,
and walk in it and find rest for your souls. - Jer 6:16
Micro 335 & 355
deerboyarchery.wixsite.com/trinitystrings
[email protected]
<{{{><
-
Micro.slayer
- Posts: 141
- Joined: Tue Mar 07, 2017 8:24 pm
Re: Ramcat 125???
Use the small silicone/rubber "o " rings 1-2 might due. To keep tight when turning blade up and away from stirrup