They all shoot fast enough to kill deer reliably with well placed shots. That's what's really important.
Micro 335
Matrix 380
Boofest 2016 Matrix 330
Trigger Techs all around
125 gr. QAD Exodus (Micro) 100 gr Slicks otherwise
Strings by Vixenmaster
Arrows by Xcaliber
wsisk wrote:Im shooting quills 375 grain.What kind of speed should this combo acheive
My micro is a gen 2 with stock string.
You should understand that not all the bows shoot the same speed. Meaning, two micro 355's, side by side, could be shooting 360fps and 345fps. That being said, the rough guess is to subtract 1fps for every 3gr heavier than 350gr (which is the arrow weight Excalibur uses to rate for advertised speeds). So, your 375gr arrow is 25gr heavier than 350gr which should equal about 8fps of speed loss.
Paul
,
You're only paranoid if everyone isn't out to get you.
Keep your friends close and your enemies closer.
My enemy's friend is also my enemy.
You may want to specify which generation Micro 335 your inquiring about as they can very some.... The first generation made prior to 2016 with it's forward swept riser is considered by many to be an "over acheiver", often comming in above 335 fps with a 350 gn test arrow....
The newer 2016 model has a swept back riser and 1/2" longer rail to help recover the speed loss that would otherwise result if the rail was left the same length as the 2015 models. This new model does exhibit less stress on the limbs in attempting to reduce any reliability issues. This one may not give you the speeds the first model does... My new gen II was put thru the crono at Excal by Mike in C/S and gives an honest 335.4 and 335.6 when he tested them on their equipment.
Gene
Camo Micro 355 w/ XB30 SR Pro & TT trigger
Camo Matrix 380 W/ XB 30SR Pro & a Boo trigger
Very Nice 98 Jeep Tj
Sweet old 73 Bronco ( 2nd Owner)
Scamp tralier
Could someone please post a picture of a Gen 1 riser compared to a Gen 2. I bought two micro 335's this past September 2016 brand new, but I am not sure what Gen risers I have on these bows. Thanks
Crackedlimb wrote:Could someone please post a picture of a Gen 1 riser compared to a Gen 2. I bought two micro 335's this past September 2016 brand new, but I am not sure what Gen risers I have on these bows. Thanks
You will find this forum to be stacked with info, you just have to spend some time and search for it. Here is exactly what you are looking for.
The difference is very small and both are actually swept back. The first production risers are a three degree swept back and the current production run is a six degree swept back with extra mainframe length as Gene said.
Paul
You're only paranoid if everyone isn't out to get you.
Keep your friends close and your enemies closer.
My enemy's friend is also my enemy.