I have a brand new set of Blem limbs on my 380, the tiller is off 1/16".
Have not shot it past 10yrds yet.
I am wondering if anyone else has had this problem, and if there bow shot ok.
I am going to try and get to the range this week and shoot some distance.
Tiller on 380 Matrix
Moderator: Excalibur Marketing Dude
-
- Posts: 13618
- Joined: Wed Sep 14, 2005 3:51 pm
- Location: Western Ky
Re: Tiller on 380 Matrix
That is minute amount of off Tiller n you can shoot an adjust windage on scope. Should do fine, i had one that was 3/4" diff once cocked but it shot 2" groups at 30 yds
Re: Tiller on 380 Matrix
There s no telling until you shoot it. That much isn't too much for smallish fixed broadheads but might be for 1 1/2" fixed to 40 yards, depending on your expectations. For a mechanical i doubt you'll see anything.
Some people just like stepping on rakes
Re: Tiller on 380 Matrix
I have had 5 Excalibur Crossbows all purchased new, and everyone of them was a tad bit off on tiller, and it never showed up while shooting out to 50 yards. Like said, check it out.
It’s not the way you rock, it’s the way that you roll!
Re: Tiller on 380 Matrix
Thanks for the replies guys.
-
- Posts: 13618
- Joined: Wed Sep 14, 2005 3:51 pm
- Location: Western Ky
Re: Tiller on 380 Matrix
Its the diff in limbs n string as the sit on the Riser. String may not be sq. to the frame if'en a limb is weak. I have had them be 3/4" diff when cocked, not good if'en you plan on shootin 40-50 yds or more
Re: Tiller on 380 Matrix
Oh ok I never noticed that I'll have to check mine
If guns cause crime, all of mine are defective