Nock weight

Ragumup · Post by **Ragumup** » Sat Mar 31, 2018 6:02 am

Hi this place is a real wealth of knowledge

Question how to make my flat plastic nocks weigh the same as my lumenoks ... I’m thinking glue ? Or glue something in the back of nock ...? Thanks in advance

Normous · Post by **Normous** » Sat Mar 31, 2018 6:06 am

An 18 to 20 grain threaded insert or set screw either threaded in or glued will uniform your inserts.

Bcxbow · Post by **Bcxbow** » Sat Mar 31, 2018 6:27 am

A 10-32 x 1/2” set screw screwed into the flat plastic nock will put you within half of a grain of a Lumenok.

roly · Post by **roly** » Sat Mar 31, 2018 12:22 pm

I’ve used Allen screws also.
Now I have been using tiny split shot. I put some glue in the insert then add split shots till I get the weight I want then put some more glue on top. The split shot I have start at about 5 gr’s.
Just another option.

Kegbelly · Post by **Kegbelly** » Sat Mar 31, 2018 8:03 pm

I did sort of the same thing... shaved a tad off a lead pellet to get the weight right and super-glued it inside the nock. I made a few of them and it works well.

Excalibur Crossbow Forum

Nock weight

Nock weight

Re: Nock weight

Re: Nock weight

Re: Nock weight

Re: Nock weight