Question on swapping limbs

[redfin]

I swapped my limbs on my Micro 355 and now I have this gap while uncocked between limb and riser. I do not remember it on the old limbs but wanted to know if this is normal. I wanted to get sighted in this weekend. It seems logical that the replacement limbs should have come with a thicker limb pad. The new limbs did look thinner than the old ones in this area where the gap is.

Everything is torqued down properly and I triple checked everything. I tried to attach a pic but the message I get is that the board attachment quota has be reached. If anyone can help with that I can post a pic.

[Boo]

Email the pic to me and I'll post it. Click my name and you'll see an email link

[redfin]

Email sent. Thanks for the response.

[xcaliber]

I get a feeling every time I swap limbs or tear down the front end and reassemble it. You have the same sense I get, so just measure the width of the two sets, maybe there is no issue. Remember, we’ll all be behind you when you shoot, waaay behind you!

Pictures are worth a thousand words.

[Boo]

What you are seeing is what was there before. The riser is relieved slightly so the riser profile can act like a rocker. The picture below is my 355 Suppressor where you are seeing the gap

[xcaliber]

I see a larger radius on the limb edge which makes the gap appear to be larger. I say you’re good to go.

[redfin]

Thanks guys. Never hurts to be sure. This is a great forum. Thanks.

[xcaliber]

We’ll be waiting for your report Sir!

[redfin]

Very happy with the new limbs. Through the chronograph I am getting an average of 322fps with my 400 grain quills. I had very good flight with the magnus stingers in 150grain out to 40 yards.

[xcaliber]

Great to hear, nothing like doing it yourself!