Hey Digger (and others that do this)
Moderator: Excalibur Marketing Dude
Hey Digger (and others that do this)
Saw the photo you posted on the "limbs" thread.......have you noticed any change in point of impact when you remove and reinstall the limb assembly as in the photo??? Sure would be a lot easier to transport an Excalibur if it can be taken down and reassembled without a change in point of impact!!
DITTOGaryL wrote:No change....
I found no change in POI even when i went to a lite limbs prod
Digger
2008 Y25 Relayer #593 Boo string, lumizone
2-1984 Relayer,
2-1992 Wolverine
Excal Phoenix, acudraw, VARizone
T.P. Titan TL4, acudraw 50, Varizone
Vixen, Steddy Eddy, Varizone
Martin Rage
Martin Jaguar
PSE Infinity
2008 Y25 Relayer #593 Boo string, lumizone
2-1984 Relayer,
2-1992 Wolverine
Excal Phoenix, acudraw, VARizone
T.P. Titan TL4, acudraw 50, Varizone
Vixen, Steddy Eddy, Varizone
Martin Rage
Martin Jaguar
PSE Infinity
Re: Hey Digger (and others that do this)
i shot the 3d circuit a couple of years ago with a fella that used to do as you mention...from a hunting standpoint as far as change in poi, you would notice little or no difference...from a tackdriving state of repetitiveness, there is a small difference...usual adjustments for this fella would be a click (or so) either up or down...keep in mind, these folks are shooting for one inch sized 12 rings up to 50 yards...not a big deal, but it is worth noting that the front assembly will not seat itself "exactly" as before...GonHuntin wrote:....have you noticed any change in point of impact when you remove and reinstall the limb assembly as in the photo??? Sure would be a lot easier to transport an Excalibur if it can be taken down and reassembled without a change in point of impact!!
wayne...