phoenix question

lucky strike · Post by **lucky strike** » Thu Feb 01, 2007 3:40 am

can someone give me the length of the unstrung bow from tip to tip?
i'm hoping they(the limbs) are a bit shorter as well as the stock than my exocet.
and also ,i would like to see excalibur put a small handle on the side of the rail and on the stock portion that could be detached and put on either side about mid point. it would make carrying a lot easier in tight places with the limbs being vertical.

thanks, ls

Cougar · Post by **Cougar** » Thu Feb 01, 2007 5:56 am

L.S. that measusement is 36 5/8 inches on my Phoenix.

GaryL · Post by **GaryL** » Thu Feb 01, 2007 7:21 am

Check the catalog on main page, however inless they have changed something of late all the Excals are the same width on the limbs ....

shurite44 · Post by **shurite44** » Thu Feb 01, 2007 11:01 am

Limbs are all the same, except the paradox.

crazyfarmer · Post by **crazyfarmer** » Thu Feb 01, 2007 11:18 am

the only this different from the exocet would be the rail length.. I think its about 1-1.5inches shorter. So yes the bow will be about 1.5 total inches shorter, but everything else is the same.

if you are looking for a short limb bow, then you will have to check into the compounds