problems with new easton shafts?????

bzz · Post by **bzz** » Wed Oct 07, 2009 11:17 pm

i went out and bought a pack of the new easton bolts as i was mounting my braod heads i noticed it kept turning but not tighting .then i tried 3 shoots with the fied tips and when i pulled the arrow out the tips seperated from the shft. they grouped all about 1 inch apart thought ,that made me smile any suggestions ???should i take them back or should i be glueing them???

dick195252 · Post by **dick195252** » Thu Oct 08, 2009 5:56 am

Your call they are defective! If not to far away i would return them. At the least i would glue the inserts in!

vixenmaster · Post by **vixenmaster** » Thu Oct 08, 2009 8:15 am

If you have travel more than 10 miles round trip ? then just glue inserts back in and shoot on

kanehill · Post by **kanehill** » Thu Oct 08, 2009 9:40 am

Had the same problem. The factory uses a very small amount of glue, if any. I just glue them back in the shaft myself.

diesel · Post by **diesel** » Thu Oct 08, 2009 1:33 pm

Put some Goat tuff glue on them and be done with it.