low drag vanes

CHski65 · Post by **CHski65** » Tue May 24, 2011 6:58 am

What is the best 2 inch vane that doesnt drag in well of the rail. I m looking at flex fletch for starters. tanks

vixenmaster · Post by **vixenmaster** » Tue May 24, 2011 9:54 am

Well of rail i assume is the arrow vane/feather slot/channel .056 Blazers do touch barely & .056 Fusions i knowed the Fusion 3" are .045 & they don't touch/rub. So i would say any from.045 up to .052 should clear easy

pokynojoe · Post by **pokynojoe** » Tue May 24, 2011 12:30 pm

Ch
I had some success with the AAE Max target vanes in 2" shield cut version. However, I need to qualify that success. This was with field points or nibbs, I'm not sure they would stabilize broadheads, never tried it. If you'd care to try some, PM me your address, and I'll send you some in good time.

All the best
Joe

See4miles · Post by **See4miles** » Wed May 25, 2011 10:12 pm

Blazers have been re-designed and are slightly lower in height. You may want to look at them again.

philman · Post by **philman** » Thu May 26, 2011 10:02 am

Check out the Blazer X2 vane by bohning.

j.krug · Post by **j.krug** » Fri May 27, 2011 5:36 pm

vixenmaster wrote:Well of rail i assume is the arrow vane/feather slot/channel .056 Blazers do touch barely & .056 Fusions i knowed the Fusion 3" are .045 & they don't touch/rub. So i would say any from.045 up to .052 should clear easy

I just switched all my arrows to 3" Fusions and I'm very pleased with them.
They look sweet and are holding up pretty good so far.

Excalibur Crossbow Forum

low drag vanes

low drag vanes

Re: low drag vanes

Re: low drag vanes

Re: low drag vanes

Re: low drag vanes

Re: low drag vanes