Does anyone know if a excalibur cheekpiece fits on a Ibex?
I followed the instructions but the cheekpiece doesn't clip onto the stock and the screwhole doesn't line up as well.
Excalibur cheekpiece
Moderator: Excalibur Marketing Dude
-
- Posts: 2856
- Joined: Mon Oct 25, 2010 9:02 pm
- Location: S.E. Georgia
- Contact:
Re: Excalibur cheekpiece
Yes it will fit...i cursed worse than a sailor before i snapped it on my ibex, but it will fit. I warmed mine up with a heat gun on low setting, have heard of some putting it in the oven long enough to get it warm. Getting it warm seems to help.
Good luck
Good luck
Bulldog m380 blackout
Micro 355
Matrix 350LE
Vixen II
Proud member of the Georgia Meat Hunter's Association
"Shooting tomorrow's trophy's...today"
Micro 355
Matrix 350LE
Vixen II
Proud member of the Georgia Meat Hunter's Association
"Shooting tomorrow's trophy's...today"
Re: Excalibur cheekpiece
When I went to clip it on stock the screwhole was half an inch away from stockholders.So I looked at bottom of cheekpiece and the ribs were flush against stock.
I thought I was going to have to trim ribs down to make it fit.
I thought I was going to have to trim ribs down to make it fit.
Re: Excalibur cheekpiece
It should fit. I put one on mine and it was a little hard to snap on but it did.
I think theres a video that shows how to snap it on. I think its on the website but not sure where I saw it.
I think theres a video that shows how to snap it on. I think its on the website but not sure where I saw it.
Ibex
NRA Life Member
NC Lifetime Sportsman
NRA Life Member
NC Lifetime Sportsman
-
- Posts: 4804
- Joined: Thu Jul 30, 2009 5:06 pm
- Location: Ft. Worth, Texas
Re: Excalibur cheekpiece
Bigger hammer!!!!
Re: Excalibur cheekpiece
I "tapped" mine on with a rubber mallet and then "tapped" it a bit more until the screw hole lined up. I've heard of folks soaking it in hot water before installing it to help it pop on better.
Gun control is like trying to reduce drunk driving by making it tougher for sober people to own cars.
Vortex
Trigger Tech 2.5 Trigger
ShadowZone Scope
S5 with dB Killer Bumpers
Boo String
Big John Zombie Slayers
Rage Broadheads
Vortex
Trigger Tech 2.5 Trigger
ShadowZone Scope
S5 with dB Killer Bumpers
Boo String
Big John Zombie Slayers
Rage Broadheads
- maine hunter
- Posts: 2347
- Joined: Thu Apr 19, 2012 6:23 pm
- Location: maine
- Contact:
Re: Excalibur cheekpiece
they do go on hard, but when it's on......nice!!!!
355 matrix, big johns arrows- zombieslayers, g5 montecs, strikers. Vortex big johns arrows- zombieslayers g5 montecs 125. Lumenoks.
Re: Excalibur cheekpiece
I put mine on with a "C" clamp. It worked fine.
Re: Excalibur cheekpiece
I messed around for a while trying to make it fit, then it just popped on easily, but I have no idea how I did it lol
Exocet 200
S5 System
Shadowzone
S5 System
Shadowzone
Re: Excalibur cheekpiece
I messed around for a while trying to make it fit, then it just popped on easily, but I have no idea how I did it lol
Exocet 200
S5 System
Shadowzone
S5 System
Shadowzone