Excalibur cheekpiece

[fuel80guy]

Does anyone know if a excalibur cheekpiece fits on a Ibex?
I followed the instructions but the cheekpiece doesn't clip onto the stock and the screwhole doesn't line up as well.

[georgiaboy]

Yes it will fit...i cursed worse than a sailor before i snapped it on my ibex, but it will fit. I warmed mine up with a heat gun on low setting, have heard of some putting it in the oven long enough to get it warm. Getting it warm seems to help.
Good luck

[fuel80guy]

When I went to clip it on stock the screwhole was half an inch away from stockholders.So I looked at bottom of cheekpiece and the ribs were flush against stock.
I thought I was going to have to trim ribs down to make it fit.

[houser52]

It should fit. I put one on mine and it was a little hard to snap on but it did.
I think theres a video that shows how to snap it on. I think its on the website but not sure where I saw it.

[flightattendant100]

Bigger hammer!!!!

[j.krug]

I "tapped" mine on with a rubber mallet and then "tapped" it a bit more until the screw hole lined up. I've heard of folks soaking it in hot water before installing it to help it pop on better.

[maine hunter]

they do go on hard, but when it's on......nice!!!!

[rich l]

I put mine on with a "C" clamp. It worked fine.

[Bullzeye]

I messed around for a while trying to make it fit, then it just popped on easily, but I have no idea how I did it lol

[Bullzeye]

I messed around for a while trying to make it fit, then it just popped on easily, but I have no idea how I did it lol