What size vanes?

jd4223 · Post by **jd4223** » Fri Oct 12, 2012 7:54 pm

I'm tempted to try the new QuikFletch Vanes by NAP.I'm shooting the Firebolts Carbon with 4"vanes.Should I go with 3" or 2" vanes with the QuikFletch?

georgiaboy · Post by **georgiaboy** » Fri Oct 12, 2012 8:52 pm

I shoot 2" blazers...my votes for 2"

Bullzeye · Post by **Bullzeye** » Fri Oct 12, 2012 10:56 pm

I switched to the QuickFletch 2in. Blazers, and I find they group much better than the original vanes on my Firebolts.

HellBilly-X · Post by **HellBilly-X** » Sat Oct 13, 2012 2:59 am

2in Blazers on my Firebolts. Good arrow flight & stacks the arrows out to 50yds.

Nighthunter · Post by **Nighthunter** » Sat Oct 13, 2012 4:40 am

I did a lot of internet research on vanes and found that the majority prefer 2" Blazers and the Arizona EZ Fletcher made for crossbow arrows. This is what I purchased but have not had time to experiment yet, but there is simply too much overwhelming testimony to the fact that the 2" Blazers work; to ignore it. You can research for yourself, but I don't believe you will be disappointed...

Hester0305 · Post by **Hester0305** » Sat Oct 13, 2012 9:56 am

If you use the quick fletch don't fletch them too far at the end of the arrow because I had some that would'nt touch the string when loaded in the crossbow. The bottom vane must have been hitting something in the trigger mechanism. This caused a partial dry fire with that arrow. I went back to fletching my own with the Arizona E-Z Fletch. The other ones I did with the quick fletch with 2 in. Blazers flew great. Good Luck

Bullzeye · Post by **Bullzeye** » Sat Oct 13, 2012 12:36 pm

When I put on the QuickFletch vanes I just measured my old vanes to the rear of the arrow and put the Quick Fletch exactly in the same spot.

Excalibur Crossbow Forum

What size vanes?

What size vanes?

Re: What size vanes?

Re: What size vanes?

Re: What size vanes?

Re: What size vanes?

Re: What size vanes?

Re: What size vanes?