Question abour resetting Lumenocks

hockeyfodder · Post by **hockeyfodder** » Wed Oct 23, 2013 8:06 am

Hey All:
This is probably a dumb question but here goes anyway.
I am checking POI on some custom made arrows from Big John.
Do I have to reset the Lumenock after each shot.
I really can't imagine it would make any difference if the light is
activated while shooting, but I thought I'd check.

Thanks for your input...

cdn.redneck · Post by **cdn.redneck** » Wed Oct 23, 2013 8:24 am

when you shoot the light turn on, then you need to pull out your nock a little (until light goes off) to turn it off, luminoc lights are good for about 10h after that you need a new battery.

Normous · Post by **Normous** » Wed Oct 23, 2013 8:26 am

After each shot you turn off the Lumenok buy pull straight out (not twist) till the light shuts off. Danny Miller arrow pullers work well and any pliers used should should have the jaws coated to prevent damage to the Lumenok.
Not reseting for an extended period will result in a dead battery. If you are taking a few shots over a short time you probably do not have to reset them between shots.

Big John · Post by **Big John** » Wed Oct 23, 2013 8:47 am

Lumenoks last far longer than 10 hrs. as stated by "cdn. redneck". They will go as long as 48 hrs. consistently. As mentioned, it is good to re-set after each shot, but not necessary, to keep battery lasting longer.

Another question answered is: if you order only half your arrows with Lumenoks, and the rest aluminum rear, and you want to have them shoot exactly the same as each other, not just for spares, tell me!! For a little more I will match them all exactly in weight.

Normous · Post by **Normous** » Wed Oct 23, 2013 9:02 am

Big John wrote: I will match them all exactly in weight.

A good arrow builder right there. Matched and uniform arrows perform better.

cdn.redneck · Post by **cdn.redneck** » Wed Oct 23, 2013 9:34 am

oh, my mistake. I meant up to 40hrs
would useless if it was only good for 10hrs

Big John · Post by **Big John** » Wed Oct 23, 2013 9:53 am

That's ok cdn.redneck, I'm here for ya!

Happy Birthday by the way!

Big John

cdn.redneck · Post by **cdn.redneck** » Wed Oct 23, 2013 9:59 am

thanks big John,
must be side effect from sushi and wine from last night

Rufus · Post by **Rufus** » Wed Oct 23, 2013 10:52 am

No you can reset them when your done shooting

maine hunter · Post by **maine hunter** » Wed Oct 23, 2013 7:32 pm

enormous wrote:After each shot you turn off the Lumenok buy pull straight out (not twist) till the light shuts off. Danny Miller arrow pullers work well and any pliers used should should have the jaws coated to prevent damage to the Lumenok.
Not reseting for an extended period will result in a dead battery. If you are taking a few shots over a short time you probably do not have to reset them between shots.

x2

hockeyfodder · Post by **hockeyfodder** » Wed Oct 23, 2013 10:29 pm

Thanks for all the help and advice...and I'll be ordering more arrows Big John and that's what I'll do.
6 for the deerstand and 6 for the range...

Excalibur Crossbow Forum

Question abour resetting Lumenocks

Question abour resetting Lumenocks

Re: Question abour resetting Lumenocks

Re: Question abour resetting Lumenocks

Re: Question abour resetting Lumenocks

Re: Question abour resetting Lumenocks

Re: Question abour resetting Lumenocks

Re: Question abour resetting Lumenocks

Re: Question abour resetting Lumenocks

Re: Question abour resetting Lumenocks

Re: Question abour resetting Lumenocks

Re: Question abour resetting Lumenocks