Cheek piece accessory

[JUSTANUFF]

The cheek piece accessory offered by Excal,,,do they fit Vixen II stocks,,,

Thanks for the help!

[Mr. Cellophane]

According to past posts on the cheek piece and the Vixen II stock the answer is no. A stock X-tender will fit but the cheek piece will not. The Vixen II stock is a shoter version of the stocks that were made before the stocks with the five (5) side slashes came in production. Read some of the older posts on this
subject. I know some guys did some filing,sanding etc to make the cheek piece fit. But the cheek piece was not designed for use with the Vixen II stock.

[JUSTANUFF]

According to past posts on the cheek piece and the Vixen II stock the answer is no. A stock X-tender will fit but the cheek piece will not. The Vixen II stock is a shoter version of the stocks that were made before the stocks with the four (4) side slashes came in production. Read some of the older posts on this
subject. I know some guys did some filing,sanding etc to make the cheek piece fit. But the cheek piece was not designed for use with the Vixen II stock.

I appreciate your reply,,,I am just double checking,,,I had e-mailed Excalibur and they replied that IT WOULD fit,,,so thus my post to the experts I know are members of this forum,,,I will research some more!!

[Mr. Cellophane]

Check this old post out , vixen ii and cheepiece by FooFoo
Posted: Mon Aug 16, 2010 5:13 PM Bill troubridge also posted some info on the cheek piece and the Vixen II in these posts.

[georgiaboy]

I have a cheek piece on my vixen II...Pain in the a@# to get on, but it does fit.

[JUSTANUFF]

I have a cheek piece on my vixen II...Pain in the a@# to get on, but it does fit.

I can see the benefit,,,I have it on my bucket list,,,might be touchin base with you georgiaboy down the road if I need any help,if that's o.k.
,I see that it will probably test my patience a bit,,,
IN THE MEANTIME

I am really trying to figure out how to "cleanly" shorten my stock another 1-2 "
first while I wait to score my forward riser,,,on a good note,,I found a guy about an hour away that can machine my cast riser to the forward riser specs if I can't locate one for a reasonable price,,gotta have this project ready for the Wisconsin opener!!!

[taz3]

I put my cheek piece in hot water to help put it on easier. I tried it cold and it was a bear, but it went on super easy warmed up!

Here's my OP and some other good ideas too!
http://www.excaliburcrossbow.com/phpBB2 ... ce#p401158

[JUSTANUFF]

Thanks for all the replies,,,I appreciate the help!