33o brace height

[warningshot]

just wondering about brace height on matrix on my old excal there was two lines and on the new one there is only one , does the string need to be lined up on the mark as it arrived pre strung and of the line on rail. thanks

[ComfyBear]

The brace height (string) should be approx. 3/4" back from where the top of the riser and rail meet. If R.E.D.S. are installed, then the gap between the string and bumpers should be 1/8".

[flightattendant100]

If brace height is too high you loose a few fps. If brace height is too low you can do damage to your bow. I usually err in the side of caution.

[warningshot]

ok thanks for replys, no as much info came with the bow this time, i will keep it just ahead of line