New Micro ad

[pinshooter]

How is the noise level compared to the current matrix bows?

It's still got some volume but it "feels" quieter. Less vibration and more of a "pop" than a twang.

Thanks!

[wolv1001]

How was the "osprey" scope?

[Carnivorous]

How was the "osprey" scope?

Osprey scope???? Now you have my attention!!

[hard2draw]

Will they be legal for deer in Ont?

9.5" power stroke being the issue

[Bones]

Will they be legal for deer in Ont?

9.5" power stroke being the issue

Ya their fine ! Mnr measure's to outer edge of limb not the same as power stroke!

[galamb]

Don't confuse power stroke with draw length.

In Ontario, for all big game (deer/bear/moose) a crossbow must have a "draw length" of 300 mm (11.8").

The definition for "draw length" is:

"The draw length of a Crossbow is measured along the bolt ramp (where the bolt rests) from the outer edge of the main limb, to the anchor point (release latch mechanism) at full draw."

[TPM]

BTW, I forgot to mention, for you local guys and gals, it's at The Bow Shop in Waterloo for those who want to check it out.

[Drew]

I'm wodering if it will be possible to put these limbs on a M355. That would make a 2.7" longer power stroke and a narrow package. It would probably take the draw weight up somewhere around 320lbs I'm guessing. The limbs I would think could handle it as the flex wouldn't be much different than what the Matrix limbs see between the M310 to M380. Hmmm

It would play hell on the serving though...that would be a pretty severe string angle.

[Carnivorous]

I'm wodering if it will be possible to put these limbs on a M355. That would make a 2.7" longer power stroke and a narrow package. It would probably take the draw weight up somewhere around 320lbs I'm guessing. The limbs I would think could handle it as the flex wouldn't be much different than what the Matrix limbs see between the M310 to M380. Hmmm

It would play hell on the serving though...that would be a pretty severe string angle.

You read my mind. Lol

[Kegbelly]

Did anyone else notice this: Draw weight of 270# yields speed of 335 fps, versus say a M330 with a draw weight of 220# and a speed of 330... with the micro limbs and shorter stroke, the poundage goes way up. That's a lot of draw weight for 335 fps.... Just saying....

[amythntr]

....just learned another good piece of information....the difference between the draw length and the power stroke....I love it!

Anthony

[Normous]

One may need regular gym use to get a Micro to hit 400 + fps.

[Kegbelly]

One may need regular gym use to get a Micro to hit 400 + fps.

I was thinking the same thing! If they make a Micro 380, gosh you'd probably be pulling well over 300#. I can dig the smaller package, but that's a lot of draw weight to pull...

[Doe Master]

Then it would have to be re-named "The Samson" .

[Drew]

That would be a crazy amount of stored energy