what size rings do I need for my micro??

JLH · Post by **JLH** » Fri Feb 06, 2015 7:16 am

The stock rings aren't tall enough for the nikon, so I ordered new rings....they came, but apparently there is a size issue.... (very new to this scope thing)
Need a little insight here.
thanks!

bikerbob24 · Post by **bikerbob24** » Fri Feb 06, 2015 7:43 am

medium height is what I used on mine....

vpsaline · Post by **vpsaline** » Fri Feb 06, 2015 7:45 am

I'm in the exact same boat and I'm buying medium rings this weekend.

Deerstalker · Post by **Deerstalker** » Fri Feb 06, 2015 7:49 am

The Nikon Bolt Xr has a 1" tube and I used Weaver Medium Tactical rings to mount the scope on my Equinox.

JLH · Post by **JLH** » Fri Feb 06, 2015 7:56 am

That's exactly what I'm looking for....

and the width of the rail?
I guess I could measure, but don't have the bow with me at the moment.

Thanks

Deerstalker · Post by **Deerstalker** » Fri Feb 06, 2015 8:03 am

http://www.brownells.com/.aspx/lid=1072 ... Difference_

Check out this site for info on the scope rail.

canoe13 · Post by **canoe13** » Fri Feb 06, 2015 9:49 am

If it was just slightly off I would file down the base to fit to maintain the lowest scope mounting possible.

strum · Post by **strum** » Fri Feb 06, 2015 10:19 am

canoe13 wrote:If it was just slightly off I would file down the base to fit to maintain the lowest scope mounting possible.

This is right..you can file down the front tabs on your scope mount..I almost did it to mine as I wanted my scope as low as possible but not wanting to start cutting I ordered some weave 1" medium mounts from ebay. while they aren't fancy mounts they are comparable to the factory ones ..I think were less than 6 bucks shipped..

Deerstalker · Post by **Deerstalker** » Fri Feb 06, 2015 12:10 pm

I had to file another slot into my non-ADF scope mount rail to enable my preferred eye relief per talking with Dan & Boo. My rail came with 5 slots and now it has 6.

http://www.excaliburcrossbow.com/catalo ... _and_rings

xcaliber · Post by **xcaliber** » Fri Feb 06, 2015 5:41 pm

I got the Red Hots, 1" medium height from Cabelas, $20, and solid as an anvil!

[URL=http://s1339.photobucket.com/user/xcali ... d.jpg.html]

vpsaline · Post by **vpsaline** » Sat Feb 14, 2015 4:58 pm

I just installed the Nikon using the Millett mediums, 14$ fits like a glove with very little clearance just how I like it!

Excalibur Crossbow Forum

what size rings do I need for my micro??

what size rings do I need for my micro??

Re: what size rings do I need for my micro??

Re: what size rings do I need for my micro??

Re: what size rings do I need for my micro??

Re: what size rings do I need for my micro??

Re: what size rings do I need for my micro??

Re: what size rings do I need for my micro??

Re: what size rings do I need for my micro??

Re: what size rings do I need for my micro??

Re: what size rings do I need for my micro??

Re: what size rings do I need for my micro??