Getting new vanes for my Diablos

[excalxbowner]

I know the Diablo bolts come fletched with Vanetec vanes. Anybody know where to get them? Messed mine up pulling a couple bolts through a target.

[8ptbuk]

I would suggest changing to Blazer vanes . They control broadheads much better , Especially with a lot of helical in them .

[excalxbowner]

I would suggest changing to Blazer vanes . They control broadheads much better , Especially with a lot of helical in them .

Enough clearance might be a problem with the Blazers. They're about an 1/8" higher than the Vanetecs.

[bubba]

Call Jerry at South Shore Archery # 1-813-454-0754 he can fix ya right up.....

[8ptbuk]

BUNCH of us using them here on the forum with great results !

[excalxbowner]

8ptbuk,are you using those Blazers on BEE bolts or Diablos?

[UPSMAN]

buy yourself an EZ Fletch Bolt and put you some Blazers on the Diablos. Anybody can do it.

[8ptbuk]

I've used them on both shafts

[bubba]

Blazer's clear the rail fine. And after shooting other vanes, i have come to the conclusion. They they out perform the one's i have tried. So much so. That i am done with looking. My thought's.....

[Livtahunt]

buy yourself an EZ Fletch Bolt and put you some Blazers on the Diablos. Anybody can do it.

That's what I just did. Added reflective wraps and I'm good to go.

[excalxbowner]

Man,there is some great people on this site! Looks like its time to switch over to the blazers. gonna check out that EZ fletch

[GrassyKnoll]

The Arizona EZ Fletch Mini Bolt Fletching Jig and 2" Blazer vanes are a perfect combo.. When you are done with the jig and if you have glue residue on your jig arms, just wipe it down with acetone on a cloth, or you can fill a grass jar with acetone and just put the jig in the jar for 30 minutes then since it off with soapy water.

[Possum]

Get Blazers, EZ fletch Bolt, Loctite Super glue Ultra Gel, fletch-em-up and shoot. Blazers can be had almost anywhere.

[paulaboutform]

The Arizona EZ Fletch Mini Bolt Fletching Jig and 2" Blazer vanes are a perfect combo.. When you are done with the jig and if you have glue residue on your jig arms, just wipe it down with acetone on a cloth, or you can fill a grass jar with acetone and just put the jig in the jar for 30 minutes then since it off with soapy water.

Agreed! ...make sure you get the Arizona Rim E-Z Fletch Bolt. The mini is for setting up compound arrows < 2".

Paul

[excalxbowner]

Don't have an EZ fletch yet,so i had my local archery shop put some new blazers on my Diablos. They could only glue the Blazers on with a slight off-set. Wasn't able to get them put on with 3-4 degrees of helical like they come with. Knowing this,can i expect as good or better bolt flight than what i had before? thanks guys