BEE Shaft Size for Luminoc Install
Moderator: Excalibur Marketing Dude
BEE Shaft Size for Luminoc Install
This has probably been asked and answered on the forum a dozen times, but here goes. What size luminocs should I get to fit in my Executioners? Also, are the "stock" plastic nocks usually glued in or just pressed into place? What's the proper way to remove them?
Re: BEE Shaft Size for Luminoc Install
The inside dia. is .301 for the bee's
The plastic inserts are push in.
The plastic inserts are push in.
Re: BEE Shaft Size for Luminoc Install
If you have strong fingers you can pull them out, you can use pliers, just be careful not to scar them. I use my Danny Miller arrow pullers.
Re: BEE Shaft Size for Luminoc Install
go to their web site and the will walk you through the installation very informative.
W.M.
W.M.
Re: BEE Shaft Size for Luminoc Install
Lumenok # GTF
EXCALFFLICTION 1991 ->>----------> 2024
Matrix 355
Huskemaw and Leupold crossbow optics.
Boo Strings
SWAT BH's and TOTA heads.
Teach Your Family How To Hunt So You Don't Have To Hunt For Your Family
Matrix 355
Huskemaw and Leupold crossbow optics.
Boo Strings
SWAT BH's and TOTA heads.
Teach Your Family How To Hunt So You Don't Have To Hunt For Your Family
Re: BEE Shaft Size for Luminoc Install
Normous wrote:Lumenok # GTF
You are correct ..My gt arrows use .301 GTF and work on Zombies ..