BEE Shaft Size for Luminoc Install

[ghall6292]

This has probably been asked and answered on the forum a dozen times, but here goes. What size luminocs should I get to fit in my Executioners? Also, are the "stock" plastic nocks usually glued in or just pressed into place? What's the proper way to remove them?

[roly]

The inside dia. is .301 for the bee's

The plastic inserts are push in.

[roly]

If you have strong fingers you can pull them out, you can use pliers, just be careful not to scar them. I use my Danny Miller arrow pullers.

[W.Miguire]

go to their web site and the will walk you through the installation very informative.
W.M.

[Normous]

Lumenok # GTF

[sproulman]

Lumenok # GTF

You are correct ..My gt arrows use .301 GTF and work on Zombies ..