I just put the string back on my Dad's vixen and noticed that there was no mark for the proper brace height. My exomag has a mark and I was going to measure it and use that measurment for the vixen. What do you guys think?
Camper
Brace Height for the vixen
Moderator: Excalibur Marketing Dude
Brace Height for the vixen
Time and Patience the best advice my Grandfather gave me.
Camper
Camper
I think 1 1/8" from end of rail Thats where I set mine on the Vixen...
My Vixen has a red dot on each side of the rail at 1 1/8".
My Vixen has a red dot on each side of the rail at 1 1/8".
Last edited by GaryL on Fri Oct 01, 2004 2:13 pm, edited 1 time in total.
Always learning!!
Home fer now!
Home fer now!
GaryL is right. The string should be 1 1/8 " on the rail up from the riser. If you are putting a new string on start it at 1 1/2 inches from the riser. I had a older Wolverine without a brace height line, I measured 1" from the riser and scribed a mark across the rail. or take some bright red nail polish and make a dot on the side of the rail 1" from the riser, both methods work.
Digger
Digger
Digger
2008 Y25 Relayer #593 Boo string, lumizone
2-1984 Relayer,
2-1992 Wolverine
Excal Phoenix, acudraw, VARizone
T.P. Titan TL4, acudraw 50, Varizone
Vixen, Steddy Eddy, Varizone
Martin Rage
Martin Jaguar
PSE Infinity
2008 Y25 Relayer #593 Boo string, lumizone
2-1984 Relayer,
2-1992 Wolverine
Excal Phoenix, acudraw, VARizone
T.P. Titan TL4, acudraw 50, Varizone
Vixen, Steddy Eddy, Varizone
Martin Rage
Martin Jaguar
PSE Infinity