I never knew that such a bracket existed until I seen a post by Big Bow Man on CBN. I have the EXT crank on my bow full time as I shoot a lot at the range (Benefits of being retired ) the crank had a lot of play and rattled quite a bit when installed on the bow so I shimmed the brackets and it is now a nice tight fit on the brackets and silent, So I decided that it would be nice to have the crank handle attached to the bow as well rather than having it in my pocket. I ordered the bracket and installed it today, again it was kind of loose and noisy so I added a couple of strips of electrical tape on both sides of the bracket and this did the trick no noise. I feel so comfortable that I will be hunting with both the crank and the handle attached to the bow.
Micro Axe 340 Kryptek Raid
Bushnell Elite 4200 2.5x10x40, HHA Tetra XB
Dr Stirrup Bumpers
BEE'S 400 grains with ignitor lighted nocks
Boo force 10 strings
....what a great idea....I had ordered one last year and couldn’t figure where to put it....now I know where it will call home on my AXE....thanks for the post!
In a tough situation and wonder where God is; ...the Teacher is always quiet during the test.
Looks good, I was going to do that exact same thing a month or two back, but my bulldog stock doesn't have a such a nice clean obvious spot where it would be in the way.
) the crank had a lot of play and rattled quite a bit when installed on the bow so I shimmed the brackets and it is now a nice tight fit on the brackets and silent, So I decided that it would be nice to have the crank handle attached to the bow as well rather than having it in my pocket. I ordered the bracket and installed it today, again it was kind of loose and noisy so I added a couple of strips of electrical tape on both sides of the bracket and this did the trick no noise. I feel so comfortable that I will be hunting with both the crank and the handle attached to the bow. 
