What's your favorite brand/type of fletching cement?

Maritimer · Post by **Maritimer** » Sat Jun 18, 2005 5:06 pm

I don't use glue anymore, all I use now it the fletching tape. It is a little expensive but I can fletch a arrow in less than 5 minutes. There is no drying time, I don't know how it would work on plastic vanes for all I use are feathers.

Digger · Post by **Digger** » Sat Jun 18, 2005 5:24 pm

I have used Fletch-Tite for vanes for a number of years and have not lost a vane yet at bolt level. for feathers I use Loc-Tite Quick setting gel.

Digger

Woody Williams · Post by **Woody Williams** » Sat Jun 18, 2005 5:46 pm

Arizona Fastset Gel..

http://www.cabelas.com/cabelas/en/templ ... stid=23309

gad · Post by **gad** » Sat Jun 18, 2005 6:10 pm

I am also using the AAE speed set gel.
Its really good. And it's fast to fletch the bolts with this glue. It's almost
instantly.

I am using it with the martin j8 fletcher and nock adaptors on the bolts.

DOXNUT · Post by **DOXNUT** » Sat Jun 18, 2005 7:48 pm

Saunders NPV cement...sure has proven it's self over the years

GREYWOLF · Post by **GREYWOLF** » Sat Jun 18, 2005 9:58 pm

AAE speed set , It's all we have been useing in our shop for over a year now, on carbon , alum. and wood also over wraps. And we have had no complaints or problems . Pluss you get the job done in a quarter of the time GREYWOLF

wabi · Post by **wabi** » Sat Jun 18, 2005 10:28 pm

I have tried a few other cements over the years, but always end up switching back to the one I have used for years - Fletch-Tite!

Kevin 2 · Post by **Kevin 2** » Sat Jun 18, 2005 10:37 pm

I use Bohning Premium Feather Fletching Tape with feathers. Works great and has no dry time. It only works on feathers. Fletch-Tite on vanes. Never had a prolbem.

Kevin

dryhorn2 · Post by **dryhorn2** » Sun Jun 19, 2005 6:37 pm

What do you need to use with the Bitzenburger jig for crossbow bolts with the flat nock?

GREYWOLF · Post by **GREYWOLF** » Sun Jun 19, 2005 10:08 pm

remove the flat nock , and use a GOLD TIP series 22 vert. bow nock to fletch , then switch the nocks back and glue it in place again . GREYWOLF

Digger · Post by **Digger** » Sun Jun 19, 2005 10:48 pm

dryhorn2, Glue a nock to field point and screw it the back of Excal insert. I use these in my Bitz.

Digger