how to remove the stock?

ch312 · Post by **ch312** » Mon Jun 27, 2005 6:59 pm

i take out the 2 screws that are on the bottom of the stock. one is on the forend and the other right behind the trigger guard.

then try to take it apart but the stock is still attached to the rest of the bow rosk solid. is there a screw im missing or is it just a tight fit?

Digger · Post by **Digger** » Mon Jun 27, 2005 8:15 pm

Thats the only screws that hold the stock on. My stock was sticky and I used a rubber hammer to loosen mine. A good whack or two on the rail and it came right off.

Digger

Mark · Post by **Mark** » Mon Jun 27, 2005 8:53 pm

Digger is right the factory stock is tight , just be careful not to damage the trigger when you remove or replace the stock.

Mark

ch312 · Post by **ch312** » Mon Jun 27, 2005 9:00 pm

Thanks guys im gonna go see if i can break something now