crankaroo problem

Todd the archer · Post by **Todd the archer** » Wed Aug 05, 2009 10:01 pm

Hi guys, Just wanted to know if anyone has problems mounting a crankaroo on their stock. Mine doesn't go down far enough so that the pin can screw into the hole. Tried e-mailing excalibur service but nobody has responded yet.

Thanks, Todd

mikej · Post by **mikej** » Wed Aug 05, 2009 10:05 pm

try calling them

lscha · Post by **lscha** » Wed Aug 05, 2009 10:11 pm

Call Dan Miller 740-483-2312 Horizontal Archery

Tar Heel · Post by **Tar Heel** » Wed Aug 05, 2009 10:34 pm

I have read on the forum of this problem before, On some of the newer excals the hole has to be drilled slightly larger so the pin on the crank will go in.

Tar Heel

dick195252 · Post by **dick195252** » Thu Aug 06, 2009 3:43 am

My screw was really tight when i first got mine, but now after hundreds of arrows being shot through it, it is just right. so you may have to drill it a little bigger.

Todd the archer · Post by **Todd the archer** » Thu Aug 06, 2009 5:35 pm

Thanks for all your replies everybody. Seems like an easy fix. I will redrill the hole when I get a chance.

Thanks again, Todd