Hi all.(New to forum) I just bought a Matrix 355, when watching the instruction video it says when setting brace height set between the two lines on riser but my Matrix only has one line. The instruction book say to set brace height between1"-1.5" from joint. Can someone clarify this?
Reddog
Brace height??
Moderator: Excalibur Marketing Dude
-
- Posts: 65
- Joined: Wed Sep 24, 2014 5:21 pm
Re: Brace height??
I have the axiom, and my book also said 1"-1.5" from the joint mine doesn't have any lines on the rail, I measured off of the riser joint and used a sharpie to put a line at the 1" Mark and one at the 1.5" Mark I just try to keep the string right in the middle of the marks and it seems to be just fine and shoots good.
If you have the string bumpers on it the you just keep it a small distance from them and you are good, at least that's what I have read here on the forums but I'm sure someone with more knowledge than me can straighten it out for ya.
If you have the string bumpers on it the you just keep it a small distance from them and you are good, at least that's what I have read here on the forums but I'm sure someone with more knowledge than me can straighten it out for ya.
Re: Brace height??
I keep the string approx. 1 to 2 string widths off the rubber bumpers on my 355
IN GOD WE TRUST
Jeff
animals are killed, crops are harvesteD
REVX
matrix 355
BE executioners and zombies, w/110 brass
SWAT BROADHEADS
Boo string
Dagriz knife
Jeff
animals are killed, crops are harvesteD
REVX
matrix 355
BE executioners and zombies, w/110 brass
SWAT BROADHEADS
Boo string
Dagriz knife
Re: Brace height??
I do the same on my Vortex.Deaf jeff wrote:I keep the string approx. 1 to 2 string widths off the rubber bumpers on my 355
2008 Vortex 200
Vari-zone Scope
150 Grain Boltcutters
NGSS
Vari-zone Scope
150 Grain Boltcutters
NGSS
Re: Brace height??
My 355 has no marks on the rail for the brace height. The book says that your brace height can be between 5/8 and 1 inch from the "joint" where riser and rail meet. My bow seems to like being at 3/4". I have Danny Miller's bumpers on my bow and with the 3/4" brace height, the string is about 1/8 to 3/16" away from the pads.
Re: Brace height??
X2 what deermanct said. I do the exact same, 3/4" from riser giving me about 1/8-3/16" from the rubber baby bumpers. That height seems to give you max speed without tearing up the bumpers.
Drew
2013 Matrix 355 Xtra
TT Single Stage
Nikon Bolt XR
Boo & Xcalibur flemish strings
18" BE Zombie Slayers
VPA 3-blade broadheads
2013 Matrix 355 Xtra
TT Single Stage
Nikon Bolt XR
Boo & Xcalibur flemish strings
18" BE Zombie Slayers
VPA 3-blade broadheads