Problem with the Arizona EZ Fletcher

Motto · Post by **Motto** » Thu Apr 28, 2005 10:58 am

Hello,

Thanks again for the suggestions. I just purchased 3M's Sanding Sponge with fine contoured surface. I will sand the shaft first and then clean the shaft with acetone later tonight. I am keen to see how it will work. Perhaps it is really so that the Legacy and SuperSlam have a finish which needs to be sanded.

Regards,
Motto

Motto · Post by **Motto** » Thu Apr 28, 2005 3:48 pm

Hello,

I have now sanded and cleaned the shaft with acetone. I also used NPV Saunders glue again. Well, it did not work. It seems that epoxy works. So, I have to use epoxy to fletch my arrows. At least it is really "heavy" staff.

Regards,
Motto

A.W · Post by **A.W** » Thu Apr 28, 2005 4:04 pm

I have only used my Arizona once since I got it from bj. I used alcohol (not Scotch) to clean it and put the vanes on with Bohning glue which seem to be attached solidly.

GaryL · Post by **GaryL** » Thu Apr 28, 2005 4:09 pm

A.W.

DOXNUT · Post by **DOXNUT** » Fri Apr 29, 2005 9:17 pm

Scotch Brite!!! I Have scrubbed industrial compressor parts and pump for hours.....can everyone please say " Thanks-You, 3M!" LOL

Has anyone tried using POWER BOND for insert adhesion?

GaryL · Post by **GaryL** » Fri Apr 29, 2005 9:35 pm

DOXNUT wrote:Scotch Brite!!! I Have scrubbed industrial compressor parts and pump for hours.....can everyone please say " Thanks-You, 3M!" LOL

Has anyone tried using POWER BOND for insert adhesion?

Thanks-You, 3M

No on the POWER BOND...