Bolt tips
-
- Posts: 12
- Joined: Mon Sep 05, 2005 3:32 pm
- Location: Green Cove Springs, Fl
Bolt tips
I was just target practicing this afternoon and several of the inserts on the front came off my bolts. The bolt was in the target but not the inserts. Anybody got any ideas about this. Shooting Series 22 Carbon that came with my kit. The bow is an Exomax. Getting ready for the season opener in Ga on Sept 15'th
I am a newbie to this sight so any insight would be appreciated!
I am a newbie to this sight so any insight would be appreciated!
-
- Posts: 322
- Joined: Thu Feb 12, 2004 1:20 pm
- Location: tioga co. pa.
re
this seems to be a problem with some factory built bolts ,your only option now is to repair them yourself or take them to a pro shop and have them do it.(it is a simple repair buy new inserts and two part epoxy ,clean the inside of the shaft with hot soapy water,let dry then glue them in and your ready to go ,check the rest of your bolts if they are loose pull them out and glue them also
-
- Posts: 12
- Joined: Mon Sep 05, 2005 3:32 pm
- Location: Green Cove Springs, Fl
I would guess that the inserts were left in the target when you pulled the bolt back through it. I left a blade in my broadhead target and eventually another bolt found it. Damaged the carbon bolt as it sliced down the side. Just my guess if you did pull them back through the target, if not you got me wondering.
-
- Posts: 12
- Joined: Mon Sep 05, 2005 3:32 pm
- Location: Green Cove Springs, Fl
-
- Posts: 12
- Joined: Mon Sep 05, 2005 3:32 pm
- Location: Green Cove Springs, Fl
-
- Posts: 507
- Joined: Tue Jun 24, 2003 12:25 pm
- Location: savannah,ga.
- Contact:
-
- Posts: 12
- Joined: Mon Sep 05, 2005 3:32 pm
- Location: Green Cove Springs, Fl